B-Pillar Trim: Removal: Removal-Upper
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the lower trim from the inside of the B-pillar (2). See REMOVAL .
- Unsnap and remove the trim cover (3) from the seat belt turning loop on the inside of the upper B-pillar.
- Remove the screw (1) that secures the turning loop to the seat belt height adjuster on the upper B-pillar.
- Lower the seat belt (4) and turning loop from the B-pillar.
- Remove the screw (1) that secures the lower end of the upper trim (4) to the inside of the B-pillar (3).
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the lower end of the upper B-pillar trim away from the inside of the B-pillar far enough to disengage the two spring clip retainers that secure the trim to the slots in the pillar.
- Lift the lower end of the upper trim upward to disengage the locator tab (2) from the locator hole and remove the trim from the inside of the B-pillar.