Instrument Panel: Bezel-Cluster: Removal: Bezel-Cluster

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bezel-Ignition Switch Remove (Dodge)

Courtesy of CHRYSLER LLC

Before proceeding with the following repair procedure, review all warnings and cautions.
Using a trim stick C-4755 or equivalent (1), gently pry between the ignition switch bezel (2) and the instrument cluster bezel (3) to release the snap retainers that secure the switch bezel.
Disconnect the wire harness connector from the headlamp switch (4) and remove the cluster bezel from the vehicle.

Fig 2: Bezel-Instrument Cluster Remove (Dodge)
Courtesy of CHRYSLER LLC
Using a trim stick C-4755 or equivalent (1), gently pry between the cluster bezel (2) and the instrument panel (3) to release the snap clip retainers that secure the cluster bezel.
If required, remove the headlamp switch from the cluster bezel. Refer to REMOVAL .
Remove the ignition switch bezel from the vehicle.

Fig 1: Bezel-Ignition Switch (Chrysler)

Courtesy of CHRYSLER LLC

Before proceeding with the following repair procedure, review all warnings and cautions.
Using a trim stick C-4755 or equivalent (1), gently pry between the ignition switch bezel (2) and the instrument cluster bezel (3) to release the snap retainers that secure the switch bezel.
Remove the ignition switch bezel from the vehicle.

Fig 2: Bezel-Cluster Remove (Chrysler)
Courtesy of CHRYSLER LLC
Using a trim stick C-4755 or equivalent (1), gently pry between the instrument panel (2) and the cluster bezel (3) to release the snap clip retainers that secure the cluster bezel.