LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Body - Interior & Exterior) >> Instrument Panel >> Ash Receiver >> Removal >> Ash Receiver

Ash Receiver

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Ash Receiver
GC0013461Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the gear shift center bezel from the floor console (4). See REMOVAL .
  3. Set the emergency brake and place the gear shift lever into Low gear.
  4. Using a trim stick C-4755 or equivalent (1), remove the ash receiver (2) from the instrument panel (3) by releasing the snap retainers from the instrument panel.
    Fig 2: Locating Ash Receiver Wire Connections
    GC0013460Courtesy of CHRYSLER LLC
  5. If equipped, disconnect the wire harness connectors (2) from the heated seat switches and remove the switches as required. Refer to REMOVAL .
  6. Disconnect the wire harness connector (3) from the lighter and remove the lighter assembly as required.
  7. Remove the ash receiver from the vehicle.
scientia non olet · About LEMON Manuals