LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Body - Interior & Exterior) >> Hood >> Latch Release Cable >> Removal >> Release-Hood Latch

Release-Hood Latch

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Latch Release Cable
GC0013453Courtesy of CHRYSLER LLC
  1. Remove the hood latch (2) from the vehicle. See REMOVAL .
  2. Remove the left headlamp unit from the vehicle. Refer to REMOVAL .
  3. Disengage the hood latch release cable from the integral routing clips on the headlamp mounting crossmember and the routing clips (1) along the left side of the engine compartment.
    Fig 2: Hood Latch Release Handle
    GC0013452Courtesy of CHRYSLER LLC
  4. From the passenger compartment, remove the closeout panel from beneath the left side of the instrument panel. See REMOVAL .
  5. Unseat the hood latch release cable grommet (1) from the dash panel.
  6. Remove the two screws (4) that secure the hood latch release handle (3) to the lower instrument panel reinforcement (2).
  7. Remove the hood latch release handle and cable through the passenger compartment of the vehicle.
scientia non olet · About LEMON Manuals