LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Body - Interior & Exterior) >> Exterior >> Shield-Wheelhouse - Rear >> Removal >> Shield-Wheelhouse - Rear

Shield-Wheelhouse - Rear

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Shield 1
GC0013437Courtesy of CHRYSLER LLC
  1. Raise and support the vehicle.
  2. Remove the wheels from the side of the vehicle being serviced. Refer to REMOVAL .
  3. Remove the rear portion of the body side cladding from the side of the vehicle being serviced. See REMOVAL .
  4. Remove the nuts (1), bolt (2) and the push-pins (4), that secure the lower rear wheelhouse shield (3) to the body.
  5. Remove lower rear wheelhouse shield from the vehicle.
    Fig 2: Removing/Installing Rear Wheelhouse Shield
    GC0013438Courtesy of CHRYSLER LLC
  6. Remove the push-pins (1) that secure the rear wheelhouse shield (2) to the body.
  7. Remove the rear wheelhouse shield from the vehicle.
scientia non olet · About LEMON Manuals