LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Tires & Wheels (Service Information)) >> Removal >> Tire And Wheel Assembly (Steel Wheel)

Tire And Wheel Assembly (Steel Wheel)

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Tire And Wheel Mounting
GC0012971Courtesy of CHRYSLER LLC
  1. Raise and support vehicle so tire and wheel assembly clears ground level.
    CAUTION: When removing the wheel cover, do not pry the wheel cover from the wheel. This can result in damage to the wheel cover. The wheel cover is attached using the wheel mounting nuts.
  2. Remove five wheel mounting (lug) nuts (3) from studs.
  3. Remove wheel cover (2) using care not to let tire and wheel assembly (1) fall off vehicle.
  4. Remove tire and wheel assembly (1) from hub.
scientia non olet · About LEMON Manuals