Parking Brake Lever - Right-Hand-Drive

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, see WARNING . . See CAUTION .

Raise and support vehicle. Refer to STANDARD PROCEDURE .

Fig 1: Cables At Equalizer - RHD
Courtesy of CHRYSLER LLC

NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
Disconnect front parking brake cable (5) at connector (2) to right rear parking brake cable.
Lower vehicle.
Remove driver side silencer under instrument panel. Refer to INSTALLATION .
Remove steering column opening cover. Refer to INSTALLATION .
Remove foot rest. Refer to REMOVAL .
Roll back carpet at center console to access lever mounting nuts.

Fig 2: Cable Connection At Lever - RHD
Courtesy of CHRYSLER LLC
Disconnect wiring connector at parking brake switch on lever.
Disconnect front parking brake cable strand (3) at lever connector (2).

Fig 3: Removing Cable Using Wrench
Courtesy of CHRYSLER LLC

1 - CABLE RETAINER

2 - 12-POINT BOX WRENCH
Place 13 mm 12-point box wrench (2) over cable retainer (1) at lever bracket as shown in illustration to collapse retainer fingers. Pull cable from bracket.

Fig 4: Parking Brake Lever - RHD
Courtesy of CHRYSLER LLC
Loosen nut (5) mounting parking brake lever (7) to body.
Remove nuts (8) mounting parking brake lever (7) to body.
Remove parking brake lever (7).