LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Mechanical Brake System - Base (Service Information)) >> Base - Service Information >> Hydraulic/Mechanical >> Pedal >> Removal >> Pedal-Brake

Base - Service Information: Hydraulic/Mechanical: Pedal: Removal: Pedal-Brake

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of CHRYSLER LLC
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Remove driver side silencer under instrument panel. Refer to INSTALLATION .
  3. Remove steering column opening cover. Refer to INSTALLATION .
    Fig 2: Locating Stop Lamp Switch and Pedal Rod
    GC0014396Courtesy of CHRYSLER LLC
  4. Remove brake lamp switch. Refer to REMOVAL .
  5. Remove booster push rod from pin on brake pedal. To do so:
    • Position small screwdriver between center tang on power brake booster brake pedal pin retaining clip (3).
    • Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin, then slide retaining clip off brake pedal pin.
    • Discard retaining clip (3). It is not to be reused. Install NEW retaining clip when assembling. 
  6. Slide booster push rod (5) off brake pedal pin (4).
    Fig 3: Brake Pedal Mounting
    GC0014395Courtesy of CHRYSLER LLC
  7. Remove four power brake booster (3) mounting nuts (1).
  8. Remove two nuts (1) fastening pedal bracket to upper dash panel (2).
  9. Push power brake booster (3) forward into engine compartment as far as possible by hand. Do not force it.
  10. Remove brake pedal (4).
scientia non olet · About LEMON Manuals