Brake Fluid Level Checking

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Reservoir Fluid Level Markings

Courtesy of CHRYSLER LLC

Check master cylinder reservoir fluid level a minimum of twice annually.

Fluid reservoirs (1) are marked with the words MAX and MIN to indicate proper brake fluid fill level of the master cylinder.

If necessary, add brake fluid to bring the level to the bottom of the MAX mark on the side of the master cylinder fluid reservoir (1).

Use only Mopar® brake fluid or equivalent from a sealed container. Brake fluid must conform to DOT 3 specifications. See SPECIFICATIONS .

DO NOT use brake fluid with a lower boiling point, as brake failure could result during prolonged hard braking.

Use only brake fluid that was stored in a tightly-sealed container.

DO NOT use petroleum-based fluid because seal damage will result. Petroleum based fluids would be items such as engine oil, transmission fluid, power steering fluid etc.