LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Mechanical Brake System - Base (Service Information)) >> Base - Service Information >> Hydraulic/Mechanical >> Caliper - Front Twin Piston Disc Brake >> Removal >> Caliper - Front Twin Piston Disc Brake - AWD

Caliper - Front Twin Piston Disc Brake - AWD

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, see WARNING . . See CAUTION .
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of CHRYSLER LLC
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
  3. Raise and support vehicle. Refer to STANDARD PROCEDURE .
    Fig 2: Tire And Wheel Mounting
    GC0012971Courtesy of CHRYSLER LLC
  4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
    Fig 3: Front Brake Flex Hose at Caliper - AWD
    GC0014367Courtesy of CHRYSLER LLC
  5. Remove banjo bolt (3) connecting flexible brake hose (1) to caliper (4). There are two sealing washers (2) (one one each side of hose fitting) that will come off when bolt is removed. Discard these washers; install NEW washers on installation.
    Fig 4: Front Caliper Mounting - AWD
    GC0014366Courtesy of CHRYSLER LLC
  6. While holding guide pins from turning, remove caliper guide pin bolts (1).
  7. Remove brake caliper (3) from brake adapter (2) and pads.
scientia non olet · About LEMON Manuals