LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Mechanical Brake System - Base (Service Information)) >> Base - Service Information >> Electrical >> Switch-Adjustable Pedals >> Removal >> Adjustable Pedals Switch

Adjustable Pedals Switch

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move driver's seat to full-forward, full-upward position.
  2. Disconnect battery negative cable from battery post and isolate.
  3. Remove seat belt shield from driver's seat cushion left side trim.
  4. Remove three screws fastening seat cushion side trim in place.
  5. Lift side trim from seat and utilizing slack in seat belt, turn trim over.
    Fig 1: Adjustable Pedals Switch Mounting
    GC0014350Courtesy of CHRYSLER LLC
  6. Disconnect wiring connector (2) from adjustable pedals switch (3).
  7. Remove two mounting screws (1) and remove switch (3).
scientia non olet · About LEMON Manuals