Base Brake System

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

The base brake system consists of the following components:

Brake pedal
Master cylinder
Power brake booster
Brake tubes and hoses
Proportioning valve (non-ABS only)
Disc brakes (front and rear)
Brake lamp switch
Brake fluid level sensor
Parking brake

All brakes are power assist type through the use of a vacuum operated power brake booster.

The hydraulic brake system is front/rear split on both the non-antilock and antilock braking systems. This means the front brakes are on one hydraulic circuit from the master cylinder and the rear brakes are on the other.

Front disc brakes control the braking of the front wheels; rear braking is controlled by rear disc brakes.

Some vehicles are equipped with an optional antilock brake system (ABS) with traction control. This system shares most base brake hardware used on vehicles without ABS. An Electronic Stability Program (ESP) is also available. All components differing from the base brake hardware are described in detail in the Antilock Brake System service information .

The parking brake on this vehicle is pedal-operated.

For more information on the description of any individual base brake component, refer to that component elsewhere in this service information . For information on the brake lamp switch, refer to DESCRIPTION .