LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Front Suspension & Rear Suspension) >> Rear >> Shock Absorber >> Removal >> Shock Absorber - Standard

Shock Absorber - Standard

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Refer to STANDARD PROCEDURE .
    Fig 1: Tire And Wheel Mounting
    GC0012971Courtesy of CHRYSLER LLC
  2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
  3. Position under-hoist utility jack or jack stand under outer spring link adding just enough support to keep suspension from going into full-rebound when shock absorber mounting bolts are removed.
    Fig 2: Lower Shock Mount
    GC0012978Courtesy of CHRYSLER LLC
  4. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
    Fig 3: Shock And Frame Mounting - Upper
    GC0014106Courtesy of CHRYSLER LLC
  5. Remove shock absorber (1) upper mounting bolts (2).
  6. Remove shock absorber (4).
scientia non olet · About LEMON Manuals