Hub And Bearing - RWD
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Refer to STANDARD PROCEDURE .
- Remove wheel mounting nuts (3), then tire and wheel assembly (1).
- Access and remove front brake rotor. Refer to REMOVAL .
- Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
- Remove hub nut (1).
- Slide hub and bearing off knuckle spindle.