Hub And Bearing - AWD
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Refer to STANDARD PROCEDURE .
- Remove wheel mounting nuts (3), then tire and wheel assembly (1).
- While a helper applies brakes to keep hub from rotating, remove hub nut (1) from the axle half shaft (2).
- Access and remove front brake rotor. Refer to REMOVAL .
- Remove four bolts (3) fastening hub and bearing (2) to knuckle.
- Slide hub and bearing (2) off axle half shaft (1) and knuckle.