Hub And Bearing - RWD
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to installation, inspect magnetic encoder (for wheel speed sensor) (2) for any damage and make sure any metal debris sticking to it is removed.
- Slide hub and bearing onto knuckle spindle.
- Install hub nut (1) on end of spindle. Tighten hub nut to 250 N.m (184 ft. lbs.) torque.
- Install brake rotor, then disc brake caliper and adapter assembly. Refer to INSTALLATION
. NOTE: Install a new dust cap to preserve seal integrity.
- Install NEW dust cap (2) on hub and bearing.
- Install tire and wheel assembly (1). Refer to INSTALLATION . Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) torque.
- Lower vehicle.
- Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
- Check and adjust brake fluid level in reservoir (1) as necessary.
- Road test vehicle and make several stops to wear off any foreign material on brakes and to seat brake pads.