Bar - Stabilizer - RWD

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Refer to STANDARD PROCEDURE .
Remove belly pan. Refer to REMOVAL .

Fig 1: Front Stabilizer Bar Heat Shield
Courtesy of CHRYSLER LLC
On each side of vehicle, remove screws (1) fastening stabilizer bar heat shield (3). Remove heat shield.

Fig 2: Locating Front Stabilizer Bar Retaining Bolts
Courtesy of CHRYSLER LLC
On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (1) in place.

Fig 3: Locating Retainer Halves
Courtesy of CHRYSLER LLC
On each side of vehicle, remove retainer halves (1)(2) from around stabilizer bar isolator (3).

Fig 4: Locating Front Stabilizer Bar & Bushing
Courtesy of CHRYSLER LLC
Utilizing slit, remove each isolator (1) from stabilizer bar (2).

Fig 5: Link Ball Joint At Stabilizer Bar
Courtesy of CHRYSLER LLC
On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar, then remove bar from vehicle.