LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Front Suspension & Rear Suspension) >> Front >> Bar - Stabilizer >> Removal >> Bar - Stabilizer - AWD

Bar - Stabilizer - AWD

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Refer to STANDARD PROCEDURE .
  2. Remove belly pan. Refer to REMOVAL .
    Fig 1: Link Ball Joint At Stabilizer Bar
    GC0014092Courtesy of CHRYSLER LLC
  3. On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar.
    Fig 2: Stabilizer Bar Bushing & Retainer
    GC0014091Courtesy of CHRYSLER LLC
  4. On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (3) in place.
  5. Remove stabilizer bar with isolators and retainers from vehicle.
  6. On each side of bar, remove retainers (3) from around stabilizer bar isolators (1).
  7. Utilizing slit, remove each isolator (1) from stabilizer bar (2).
scientia non olet · About LEMON Manuals