Positive - Battery To Bulkhead
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
- Remove the spare tire cover to gain access to the battery.
- Disconnect and isolate the battery negative cable (3).
- Disconnect the battery positive cable (1).
- Remove the Power Distribution Center (PDC) cover (2).
- Remove the battery positive cable to rear PDC fastener (3).
- One at a time, free the battery positive cable from the routing clips located in the rear compartment area.
- Remove the right, front seat. Refer to REMOVAL .
- Remove the right, rear seat cushion. Pull upward at forward edge of each retainer loop of the rear seat cushion to disengage retainer loops from cups in floor.
- Remove the right, front and rear door sill trim panels.
- Remove the right, B - pillar lower trim pane. Refer to REMOVAL .
- Position carpet aside to gain access to the battery positive cable.
- One at a time, free the battery positive cable from the routing clips located in the rear seat area.
- Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
- Remove the battery positive cable to bulkhead fastener.
- Remove the battery positive cable from the vehicle making note of the cable routing under the floor cross members.