LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Battery System) >> Battery System >> Battery Cables >> Removal >> Battery Cable >> Negative - Engine Compartment

Negative - Engine Compartment

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fastener Securing Negative Battery Cable To Right Front Strut Tower
GC0015616Courtesy of CHRYSLER LLC
  1. Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
  2. Remove the spare tire cover to gain access to the battery.
  3. Disconnect and isolate the battery negative cable.
  4. Remove the fastener securing the battery negative cable to the right front strut tower.
    Fig 2: Fastener Securing Negative Battery Cable To Transmission Housing
    GC0015615Courtesy of CHRYSLER LLC
  5. Raise vehicle on hoist. Refer to STANDARD PROCEDURE .
  6. Remove the fastener securing the battery negative cable to the transmission housing.
  7. One at a time, remove the battery cable retaining push pins, fasteners and routing clips until the cable is free from the vehicle.
  8. Remove the battery cable from the engine compartment.
scientia non olet · About LEMON Manuals