Positive - Battery To Bulkhead
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Position the battery positive cable in the vehicle taking care to route the cable under the floor cross members.
- Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
- Install the battery positive cable to bulkhead fastener.
- Position the bulkhead insulator back to the normal position.
- One at a time, secure the battery positive cable to the routing clips located in the rear seat area.
- One at a time, secure the battery positive cable to the routing clips located in the rear compartment area.
- Position the carpet back to the normal position.
- Install the right, B - pillar lower trim panel. Refer to INSTALLATION .
- Install the right, front and rear door sill trim panels.
- Install the right, rear seat cushion. Engage retainer loops into cup on floor kick up. Push downward at forward edge at each retainer loop of the rear seat cushion to engage retainers.
- Install the right, front seat. Refer to INSTALLATION .
- Install the battery positive cable to rear Power Distribution Center (PDC) fastener (3).
- Install the PDC cover (5).
- Connect the battery positive cable (1).
- Connect the battery negative cable (3).
- Install the spare tire cover.