LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Nag1 Automatic Transmission (Service Information)) >> Automatic Transmission Nag1 - Service Information >> Unit-ELECTROHYDRAULIC Control >> Removal >> ELECTROHYDRAULIC Unit

ELECTROHYDRAULIC Unit

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Wiring Connector Plug
GC0012698Courtesy of CHRYSLER LLC
1 - PLUG CONNECTOR
2 - ADAPTER PLUG
  1. Move selector lever to position "P".
  2. Raise vehicle.
  3. Disconnect 13-pin plug connector (1). See Fig 1. Turn bayonet lock of the adapter plug (2) anti-clockwise.
    Fig 2: Removing/Installing Electrohydraulic Unit
    GC0012712Courtesy of CHRYSLER LLC
    1 - HEAT SHIELD
    2 - ELECTROHYDRAULIC UNIT
    3 - BOLT
    4 - OIL FILTER
    5 - OIL PAN
    6 - CLAMPING ELEMENT
    7 - BOLT
    8 - 13-PIN PLUG CONNECTOR
    9 - BOLT
    10 - ADAPTER PLUG
  4. Loosen the adapter plug bolt (9) and remove from the adapter plug (10) from the transmission housing. See Fig 2.
  5. Detach oil pan (5).
  6. Remove oil filter (4).
  7. Unscrew Torx® socket bolts (3) and remove electrohydraulic control module (2).
scientia non olet · About LEMON Manuals