LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Nag1 Automatic Transmission (Service Information)) >> Automatic Transmission Nag1 - Service Information >> Seal-Output Shaft >> Removal >> Output Shaft Seal

Output Shaft Seal

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the propeller shaft. Refer to REMOVAL . Move propeller shaft to the right and tie up.
  2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
    NOTE: When removing the propeller shaft flange be certain the shim remains on the output shaft.
  3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
  4. Remove the output shaft seal with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals