LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Nag1 Automatic Transmission (Service Information)) >> Automatic Transmission Nag1 - Service Information >> K1-Input Clutch >> Disassembly >> Input Clutch K1

Input Clutch K1

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input Clutch K1 Components
GC0012805Courtesy of CHRYSLER LLC
1 - K1 OUTER DISC CARRIER 7 - DISC SPRING
2 - FREEWHEELING CLUTCH F1 8 - SPRING PLATE
3 - SNAP-RING 9 - SPRING PLATE SEALING RING
4 - OUTER DISC CARRIER SEALING RING 10 - SNAP-RING
5 - PISTON SEALING RING 11 - SNAP-RING
6 - PISTON 12 - MULTIPLE DISC PACK - REFER TO TEXT FOR CORRECT ASSEMBLY ORDER
  1. Remove snap-ring (11) from outer multiple-disc carrier (1). See Fig 1.
  2. Take multiple-disc pack (12) out of outer multiple-disc carrier (1). Note which clutch disc is removed just prior to the spring plate (8) for re-assembly. If the clutch discs are re-used, this disc must be returned to its original position on top of the spring plate.
    Fig 2: Compress Disc Spring
    GC0012806Courtesy of CHRYSLER LLC
    1 - SNAP-RING
    2 - MULTI-USE SPRING COMPRESSOR 8900
  3. Place Multi-use Spring Compressor 8900 (2) on the spring plate and compress the spring until the snap-ring (1) is exposed. See Fig 2.
  4. Remove snap-ring (1).
  5. Take out disc spring (7) and remove piston (6) by carefully blowing compressed air into the drilled oil feed passage.
  6. Remove snap-ring (3) and take out front freewheeling clutch F1 (2). Take care when removing the F1 clutch to prevent the clutch sprags from falling out. If this occurs, the clutch must be replaced.
scientia non olet · About LEMON Manuals