LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Nag1 Automatic Transmission (Service Information)) >> Automatic Transmission Nag1 - Service Information >> Bearing-Output Shaft >> Removal >> Output Shaft Bearing

Output Shaft Bearing

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Output Shaft Retaining Ring
GC0012713Courtesy of CHRYSLER LLC
1 - RETAINING RING
2 - OUTPUT SHAFT BEARING
  1. Raise and support vehicle.
  2. Remove the propeller shaft. Refer to REMOVAL .
  3. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
  4. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
  5. Remove the transmission rear oil seal with a suitable slide hammer and screw.
  6. Remove the transmission output shaft washer. Be sure to tag the washer since it is very similar to the geartrain end-play shim and they must not be interchanged.
  7. Remove the transmission rear output shaft bearing retaining ring (1). See Fig 1.
    Fig 2: Positioning Remover 9082 On Bearing
    GC0012715Courtesy of CHRYSLER LLC
    1 - BEARING REMOVER 9082
    2 - TRANSMISSION CASE
    3 - OUTPUT SHAFT BEARING
  8. Position Bearing Remover 9082 (1) over the inner race of the output shaft bearing. See Fig 2.
    Fig 3: Sliding Collar On Bearing Remover 9082 Downward Over Fingers Of Tool
    GC0012716Courtesy of CHRYSLER LLC
    1 - BEARING REMOVER 9082
    2 - TRANSMISSION CASE
    3 - COLLAR
    4 - FINGERS
    NOTE: Due to production variations in the bearing, it may not be possible to slide the collar fully downward. It is only necessary to slide the collar down far enough that the fingers securely grasp the inner bearing race.
  9. Slide the collar (3) on the Bearing Remover 9082 (1) downward over the fingers (3) of the tool. See Fig 3.
    Fig 4: Bearing Remover 9082, Transmission Case & Output Shaft Bearing
    GC0012717Courtesy of CHRYSLER LLC
    1 - BEARING REMOVER 9082
    2 - TRANSMISSION CASE
    3 - OUTPUT SHAFT BEARING
    CAUTION: Verify that the geartrain end-play shim has remained on the output shaft and against the park gear. The shim may be adhered to the bearing inner race. Retrieve the shim from the bearing and install over the output shaft and against the park gear.
  10. Remove the output shaft bearing (3). See Fig 4.
scientia non olet · About LEMON Manuals