Reservoir - Fluid

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of CHRYSLER LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL (ENGINE - 2.7L DOHC). Refer to REMOVAL (ENGINE - 3.5L). Refer to REMOVAL (ENGINE - 5.7L). Refer to REMOVAL (ENGINE - 6.1L).

Fig 2: Removing/Installing Remote Reservoir
Courtesy of CHRYSLER LLC
Remove hose clamp, then supply hose (3) at reservoir (2).
Remove hose clamp, then return hose (1) at reservoir (2).
Remove reservoir (2) from coolant bottle (4) by sliding it out of guide.