LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Steering System) >> Pump >> Reservoir >> Installation >> Reservoir - Fluid

Reservoir - Fluid

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Remote Reservoir
GC0013315Courtesy of CHRYSLER LLC
  1. Install reservoir (2) on coolant bottle (4) by sliding it into guide and allowing it to lock into place.
  2. Install return hose (1) on reservoir hose fitting. Install clamp securing hose in place.
  3. Install supply hose (3) on reservoir hose fitting. Install clamp securing hose in place.
  4. Install air cleaner housing and inlet tube. Refer to INSTALLATION (ENGINE - 2.7L DOHC). Refer to INSTALLATION (ENGINE - 3.5L). Refer to INSTALLATION (ENGINE - 5.7L). Refer to INSTALLATION (ENGINE - 6.1L).
    Fig 2: Disconnecting/Connecting Battery Cables
    GC0012970Courtesy of CHRYSLER LLC
  5. Connect battery negative cable (2) to battery post. It is important that this is performed properly. Refer to STANDARD PROCEDURE .
  6. Fill and bleed power steering system. See STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals