Pump-Power Steering, 3.0L Diesel
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate battery negative cable (2) from battery post.
- Remove engine cover.
- Remove air cleaner housing and inlet tube to throttle body.
- Remove turbocharger inlet tube.
- Remove intercooler tube resonator.
- Remove serpentine drive belt. Refer to REMOVAL .
- Siphon power steering fluid from pump reservoir. Place something below pump on belly pan to catch any fluid that spills during removal.
- Remove hose clamp (2), then supply hose (3) from pump (1).
- Unthread tube nut (2), then remove pressure hose from pump (1).
- Loosen, but do not remove, two pump mounting bolts (1) through access holes in pulley.
- Loosen, but do not remove, two mounting bolts (4) fastening front pump mounting bracket (1) to engine.
- Remove two previously loosened pump mounting bolts (1) and remove power steering pump (2) from engine.
NOTE:
The drive pulley is not serviced separately from the power steering pump.