Pump - Power Steering, 5.7L/6.1L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of CHRYSLER LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL (ENGINE - 5.7L). Refer to REMOVAL (ENGINE - 6.1L).
Remove serpentine drive belt. Refer to REMOVAL .

Fig 2: Remove/Install Supply Hose - 5.7L/6.1L
Courtesy of CHRYSLER LLC
Remove hose clamp, then supply hose (3) from pump (1).

Fig 3: Remove/Install Pressure Hose at Pump - 5.7L/6.1L
Courtesy of CHRYSLER LLC
Unthread tube nut, then remove pressure hose (2) from pump (1).

Fig 4: Remove/Install Power Steering Pump - 5.7L/6.1L
Courtesy of CHRYSLER LLC
Remove three pump mounting bolts (2) through access holes in pulley.
Remove pump (1) from engine.
If pulley needs removal, see REMOVAL .