Pump - Power Steering, 2.7L/3.5L
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate battery negative cable (2) from battery post.
- Siphon power steering fluid from pump reservoir.
- Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL (ENGINE - 2.7L DOHC). Refer to REMOVAL (ENGINE - 3.5L).
- Remove serpentine drive belt. Refer to REMOVAL .
- Remove hose clamp (2), then supply hose (3) from pump (1).
- Unthread tube nut, then remove pressure hose (2) from pump (1).
- Remove three pump mounting bolts (1) through access holes in pulley.
- Remove pump (3) from engine bracket (2).
- If pulley needs removal, see REMOVAL .