LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Steering System) >> Pump >> Hose - Pressure >> Removal >> Pressure Hose - RHD

Pressure Hose - RHD

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of CHRYSLER LLC
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Siphon power steering fluid from pump reservoir.
  3. Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL (ENGINE - 2.7L). Refer to REMOVAL (ENGINE - 3.5L). Refer to REMOVAL 9ENGINE - 5.7L). Refer to REMOVAL (ENGINE - 6.1L).
    Fig 2: Remove/Install Pressure Hose At Pump - 2.7L/3.5L
    GC0013303Courtesy of CHRYSLER LLC
  4. 2.7L/3.5L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).
    Fig 3: Remove/Install Pressure Hose at Pump - 5.7L/6.1L
    GC0013306Courtesy of CHRYSLER LLC
  5. 5.7L/6.1L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).
    Fig 4: Pressure Hose At Pump
    GC0039599Courtesy of CHRYSLER LLC
  6. 3.0L Diesel Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
  7. Raise and support vehicle. Refer to STANDARD PROCEDURE .
  8. Remove belly pan. Refer to REMOVAL .
    Fig 5: Power Steering Hose Routing - RHD
    GC0039598Courtesy of CHRYSLER LLC
  9. Remove screws (2) securing pressure hose (1) routing clamp to engine cradle.
  10. Remove screw (7) securing pressure hose (1) routing clamp to engine cradle.
  11. Unthread pressure hose tube nut (5) from steering gear.
  12. Remove pressure hose (1) from vehicle.
scientia non olet · About LEMON Manuals