Pressure Hose - AWD

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of CHRYSLER LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL (ENGINE - 2.7L DOHC). Refer to REMOVAL (ENGINE - 3.5L). Refer to REMOVAL (ENGINE - 5.7L). Refer to REMOVAL (ENGINE - 6.1L).

Fig 2: Remove/Install Pressure Hose At Pump - 2.7L/3.5L
Courtesy of CHRYSLER LLC
3.5L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).

Fig 3: Remove/Install Pressure Hose at Pump - 5.7L/6.1L
Courtesy of CHRYSLER LLC
5.7L/6.1L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
Raise and support vehicle. Refer to STANDARD PROCEDURE .
Remove belly pan. Refer to REMOVAL .

Fig 4: Hose Mounting Bracket to Cradle
Courtesy of CHRYSLER LLC
Remove screw fastening pressure hose routing clamp (1) to front of engine cradle (2).
Remove screw fastening pressure hose routing clamp to left side of engine cradle.

Fig 5: Hoses at AWD Gear
Courtesy of CHRYSLER LLC
Unthread return hose tube nut (1), then remove return hose from steering gear (2).
Unthread pressure hose tube nut (3), then remove pressure hose from steering gear (2) and vehicle.