Inner Tie Rod

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Remove outer tie rod. See REMOVAL .
Remove tie rod jam nut from inner tie rod.

Fig 1: Rack Assembly And Inner Tie Rod Bellows Heat Shields
Courtesy of CHRYSLER LLC

NOTE: If equipped with All-Wheel-Drive, it may be necessary to remove heat shield (3) above inner tie rod bellows (2) to allow better access to bellows clamp.

Fig 2: Bellows Clamps
Courtesy of CHRYSLER LLC
Remove clamp (1) securing bellows (3) to inner tie rod.
Remove clamp (2) securing bellows (3) to steering gear body.
Remove bellows (3).

Fig 3: Inner Tie Rod Hex
Courtesy of CHRYSLER LLC
Install appropriate inner tie rod removal tool on inner tie rod hex (1).
CAUTION: If inner tie rod cannot be removed using specified tools, do not use a hammer or heat to loosen. Damage to steering gear will occur. Replace entire steering gear.
Unthread and remove inner tie rod (2).

Fig 4: Restrictor Removal/Installation
Courtesy of CHRYSLER LLC
Remove travel restrictor (2) from rack gear (3).