LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Steering System) >> Column Service Information >> Wheel-Steering >> Removal >> Wheel - Steering

Wheel - Steering

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to RESTRAINTS - SERVICE INFORMATION for service procedures. Failure to do so may result in accidental deployment of the airbag and possible personal injury.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
Fig 1: Removing/Installing Driver Airbag
GC0013236Courtesy of CHRYSLER LLC
  1. Position the front wheels straight-ahead  .
  2. Fully extend or pull out adjustable steering column.
  3. Disconnect the negative (ground) cable from the battery.
  4. Remove the airbag (3). Refer to REMOVAL .
    Fig 2: Removing/Installing Steering Wheel
    GC0013237Courtesy of CHRYSLER LLC
  5. Remove the steering wheel retainer bolt (2), then slide the steering wheel (1) off the shaft.
  6. If wheel is being replaced, transfer attached components as necessary.
scientia non olet · About LEMON Manuals