Wheel - Steering

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Steering Wheel

Courtesy of CHRYSLER LLC

Align the spline on the steering wheel hub to the column shaft, then install the steering wheel (1).
Install a NEW retainer bolt (2). Tighten the bolt to 70 N.m (52 ft. lbs.).

Fig 2: Removing/Installing Driver Airbag
Courtesy of CHRYSLER LLC
Install the airbag (3). Refer to INSTALLATION .
Install the negative battery terminal on the battery. It is important that this is performed properly (including calibration of steering angle sensor if equipped with ESP). Refer to STANDARD PROCEDURE .
CAUTION: If the steering wheel is excessively off-center while driving, outside of Chassis specifications, inadvertent ESP activations may occur on a vehicle so equipped.
Test the operation of the horn, lights and any other functions that are steering column operated.