Steering Column Slider Package
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the steering column opening cover. Refer to REMOVAL .
- Remove the steering column opening reinforcement (1).
- Unlock the manual column tilt and telescoping adjustment handle, then telescope the column full forward.
- Unsnap and move the adjustment handle locking tab (3) forward as shown unlatching the handle (2) from the column.
- Using a small screwdriver (3) through the access hole, lift the retaining tab, then move the slider bar (2) toward the steering wheel until the large holes in the slots align with the casting pins (1) on the column.
- Move the slider bar (1) off the casting pins, then tip it down at the steering wheel end and slide it off the slider sled (2).
- Rotate the slider sled (1) as shown and remove it from the lever arm (2).