Sensor-Camshaft Position: Removal: 6.1L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Camshaft Position Sensor

Courtesy of DAIMLERCHRYSLER CORP.

The Camshaft Position Sensor (CMP) on the 6.1L V-8 engine (1) is bolted to the front/top of the timing chain cover (2).

Disconnect electrical connector (4) at CMP sensor.
Remove sensor mounting bolt (3).
Carefully twist sensor from timing chain cover.
Check condition of sensor o-ring.