LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Ignition System (Service Information)) >> Plug-Glow >> Removal

Section 22 (Ignition System (Service Information)): Plug-Glow: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Engine temperature must be at least 90°C (194°F) before removing glow plugs. If cylinder head is already removed, warm cylinder head to 90°C (194°F) before removing glow plugs.
  1. Disconnect negative battery cable.
  2. Remove engine cover (Refer to ENGINE - REMOVAL) or (Refer to ENGINE - REMOVAL) or (Refer to ENGINE - REMOVAL) or (Refer to ENGINE - REMOVAL) .
  3. Disconnect glow plug electrical connector (1).
    WARNING: Risk of injury to skin and eyes from handling hot or glowing objects. Wear protective gloves, clothing and eye wear.
  4. Remove glow plugs and clean glow plug bay.
scientia non olet · About LEMON Manuals