Cylinder-Ignition Key And Lock: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove bezel ignition switch ring.
Pull center console bezel loose from instrument panel. See Fig 1.

Fig 1: Locating Tab On Ignition Switch Housing
Courtesy of DAIMLERCHRYSLER CORP.
Insert ignition key and turn to the "ON" position.
Depress the locking tab on the ignition switch housing. See Fig 2.

Fig 2: Depressing Tab On Ignition Switch Housing
Courtesy of DAIMLERCHRYSLER CORP.
Pull the key cylinder from the ignition switch housing. See Fig 3.

Fig 3: Removing/Installing Key Cylinder

Courtesy of DAIMLERCHRYSLER CORP.

1 - Locking Tab Location