LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Ignition System (Service Information)) >> Coil-Ignition >> Removal >> 3.5L

Section 22 (Ignition System (Service Information)): Coil-Ignition: Removal: 3.5L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Coils
GC0002366Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery cable.
  2. Remove the intake manifold, (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL)
  3. Prior to removing the ignition coils, spray compressed air around the coil area.
  4. Unlock and remove electrical connector from ignition coil.
    Fig 2: Removing/Installing Ignition Coil
    GC0002368Courtesy of DAIMLERCHRYSLER CORP.

    On 3.5L engines, it is necessary to loosen the screws by alternating back and forth. Do not lose the spacers under the coil when loosening the screws.

  5. Remove 2 fasteners from ignition coil assembly.
  6. Remove ignition coil assembly.
scientia non olet · About LEMON Manuals