Section 22 (Ignition System (Service Information)): Coil-Ignition: Installation: 3.5L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Ignition Coil

Courtesy of DAIMLERCHRYSLER CORP.

On 3.5L engines, it is necessary to tighten the screws by alternating back and forth. Do not lose the spacers under the coil when installing ignition coils.

Install ignition coil assembly to spark plug.
Install coil screws and tighten 3.5L engines to 6.7 N.m (60 in. lbs.).
Connect the electrical connector and lock.

Fig 2: Ignition Coils
Courtesy of DAIMLERCHRYSLER CORP.
Install the intake manifold, (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION)
Connect negative battery cable.