LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (HVAC System (Service Information)) >> HVAC - Service Information >> Plumbing >> Standard Procedure >> Refrigerant System Charge >> Charging Procedure

Charging Procedure

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: A small amount of refrigerant oil is removed from the A/C system each time the refrigerant system is recovered and evacuated. Before charging the A/C system, you MUST replenish any oil lost during the recovery process. Refer the equipment manufacturer instructions for more information.
  1. Evacuate the refrigerant system. See STANDARD PROCEDURE .
  2. Connect an R-134a refrigerant recovery/recycling/charging station that meets SAE standard J2210 to the refrigerant system.
  3. Refer to the Underhood HVAC Specification Label for the proper amount of the refrigerant charge.
  4. Measure the proper amount of refrigerant and heat it to 52° C (125° F) with the charging station. See the operating instructions supplied by the equipment manufacturer for proper use of this equipment.
  5. Open both the suction and discharge valves, then open the charge valve to allow the heated refrigerant to flow into the system.
  6. When the transfer of refrigerant has stopped, close both the suction and discharge valves.
  7. If all of the refrigerant charge did not transfer from the dispensing device, open all of the windows in the vehicle and set the heating-A/C system controls so that the A/C compressor is engaged and the blower motor is operating at its lowest speed setting. Run the engine at a steady high idle (about 1400 rpm). If the A/C compressor does not engage, test the compressor clutch circuits and repair as required.
    WARNING: Take care not to open the discharge (high pressure) valve at this time. Failure to follow this warning may result in serious or fatal injury.
  8. Open the low-side valve to allow the remaining refrigerant to transfer to the refrigerant system.
  9. Disconnect the charging station from the refrigerant system service ports.
  10. Reinstall the caps onto the refrigerant system service ports.
scientia non olet · About LEMON Manuals