LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (HVAC System (Service Information)) >> HVAC - Service Information >> Plumbing >> Line-A/C Suction >> Removal >> Front Section

Front Section

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install A/C Compressor Lines
GC0013988Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. See STANDARD PROCEDURE .
  3. Remove the air cleaner housing. Refer to REMOVAL for 2.7L. Refer to REMOVAL for 3.5L. Refer to REMOVAL for 5.7L. Refer to REMOVAL for 6.1L.
  4. Remove the nut (2) that secures the front section of the A/C suction line (3) to the A/C compressor (5).
  5. Disconnect the A/C suction line from the A/C compressor and remove and discard the dual plane seal.
  6. Install plugs in, or tape over the opened suction line fitting and compressor inlet port.
    Fig 2: Removing/Installing A/C Suction Front Line
    GC0014004Courtesy of CHRYSLER LLC
    NOTE: LHD model shown in illustration. RHD model similar.
  7. Remove the nut (1) that secures the front section of the A/C suction line (2) to the rear section of the suction line (3).
  8. Disconnect the front section of the A/C suction line from the rear section of the suction line and remove and discard the dual plane seal.
  9. Install plugs in, or tape over the opened suction line fittings.
  10. Remove the front section of the A/C suction line from the engine compartment.
scientia non olet · About LEMON Manuals