LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (HVAC System (Service Information)) >> HVAC - Service Information >> Plumbing >> Line-A/C Liquid >> Removal >> Front Section

Front Section

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing A/C Lines at Condenser
GC0013999Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. See STANDARD PROCEDURE .
  3. Remove the air cleaner housing. Refer to REMOVAL for 2.7L. Refer to REMOVAL for 3.5L. Refer to REMOVAL for 5.7L. Refer to REMOVAL for 6.1L.
  4. Raise and support the vehicle.
  5. Remove the front belly pan. Refer to REMOVAL .
  6. Remove the nut (3) that secures the front section of the A/C liquid line (4) to the A/C condenser (5).
  7. Disconnect the A/C liquid line from the A/C condenser and remove and discard the dual plane seal.
  8. Install plugs in, or tape over the opened liquid line fitting and condenser outlet port.
    Fig 2: Removing/Installing A/C Liquid Front Line
    GC0014001Courtesy of CHRYSLER LLC
    NOTE: LHD model shown in illustration. RHD model similar.
  9. Lower the vehicle.
  10. Remove the nut (1) that secures the front section of the A/C liquid line (2) to the rear section of the liquid line (3).
  11. Disconnect the front section of the A/C liquid line from the rear section of the liquid line and remove and discard the dual plane seal.
  12. Install plugs in, or tape over the opened liquid line fittings.
  13. Remove the front section of the A/C liquid line from the engine compartment.
scientia non olet · About LEMON Manuals