LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (HVAC System (Service Information)) >> HVAC - Service Information >> Distribution >> Housing-HVAC >> Disassembly >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
Fig 1: Identifying Air Inlet Housing
GC0013971Courtesy of CHRYSLER LLC
NOTE: LHD model shown in illustration. RHD model similar.
  1. Remove the air inlet housing (1) from the HVAC housing and place it on a workbench. See HOUSING-AIR INLET .
  2. Remove the three screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.
  3. Remove the recirculation-air door (4) from the air inlet housing.
scientia non olet · About LEMON Manuals