Solenoid/Pressure Switch Assembly

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Solenoid/Pressure Switch Assembly & Gasket

Courtesy of CHRYSLER LLC

1 - SOLENOID/PRESSURE SWITCH ASSEMBLY

2 - GASKET

Install solenoid/pressure switch assembly (1) to case using a new gasket (2). See Fig 1.

Fig 2: Identifying Solenoid Pack-To-Transaxle Bolts
Courtesy of CHRYSLER LLC

1 - BOLTS

2 - SOLENOID AND PRESSURE SWITCH ASSEMBLY
Install bolts and torque to 13 N.m (110 in. lbs.). See Fig 2.
Install 8-way connector and torque screw to 4 N.m (35 in. lbs.).
Uncap and install transmission oil cooler lines.

Fig 3: Removing/Installing Input Speed Sensor
Courtesy of CHRYSLER LLC

1 - INPUT (TURBINE) SPEED SENSOR
Install input speed sensor (1) and torque to 27 N.m (20 ft. lbs.). See Fig 3.

Fig 4: Removing/Installing Battery Tray
Courtesy of CHRYSLER LLC
Install the battery tray (1). See Fig 4.

Fig 5: Removing/Installing Battery
Courtesy of CHRYSLER LLC

1 - BATTERY
Install the battery (1) and hold down clamp. See Fig 5.

Fig 6: Removing/Installing Air Cleaner Assembly
Courtesy of CHRYSLER LLC

1 - AIR CLEANER ASSEMBLY
Install air cleaner assembly (1). See Fig 6.
Connect battery cables.
Fill transaxle with fluid. Refer to STANDARD PROCEDURE for proper procedure.