Brake/Transmission Shift Interlock System: Adjustment

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Gearshift Knob

Courtesy of CHRYSLER LLC

1 - SHIFTER KNOB

2 - SET SCREW

Loosen set screw (2) and remove knob (1) from shifter handle. See Fig 1.

Fig 2: Removing/Installing Center Console - Typical
Courtesy of CHRYSLER LLC

1 - CENTER CONSOLE
Remove the center console assembly (1). See Fig 2.

Fig 3: Removing/Installing Shifter Bezel
Courtesy of CHRYSLER LLC

1 - BEZEL

2 - SCREW (4)
Remove shifter bezel (1). See Fig 3.
Adjust interlock cable/system as follows: Pry up on cable adjuster lock to release and allow cable to "self-adjust". Lock cable adjustment by pressing down on the adjuster lock until bottomed at the cable housing.
Verify correct system operation. Refer to the appropriate verification procedure.
Install shifter bezel (1).

Fig 4: Removing/Installing Center Console - Typical
Courtesy of CHRYSLER LLC

1 - CENTER CONSOLE
Install center console assembly (1). See Fig 4.

Fig 5: Removing/Installing Gearshift Knob
Courtesy of CHRYSLER LLC

1 - SHIFTER KNOB

2 - SET SCREW
Install gearshift knob (1) and tighten set screw (2) to 2 N.m (17 in. lbs.) torque. See Fig 5.