LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (2.4L Engine (Service Information)) >> Valve Timing >> Belt And Sprockets-Timing >> Installation >> Camshaft Sprocket(S)

Camshaft Sprocket(S)

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Camshaft Sprocket
GC0042918Courtesy of CHRYSLER LLC
1 - CAMSHAFT SPROCKET HOLDER 6847
CAUTION: Do not use an impact wrench to tighten camshaft sprocket bolts. Damage to the camshaft-to-sprocket locating dowel pin may occur.
  1. Install camshaft sprockets. Hold sprockets with Camshaft Sprocket Holder 6847 (1) while tightening center bolt to 115 N.m (85 ft. lbs.). See Fig 1.
  2. Install timing belt. Refer to INSTALLATION .
  3. Install upper and lower front timing belt covers. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals