LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (2.4L Engine (Service Information)) >> Lubrication >> Oil >> Standard Procedure >> Engine Oil Level Check

Engine Oil Level Check

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Oil Dipstick, Coolant Recovery Container & Pressure Cap
GC0021581Courtesy of CHRYSLER LLC
1 - ENGINE OIL FILL
2 - COOLANT RECOVERY CONTAINER
3 - ENGINE OIL DIPSTICK
4 - COOLANT PRESSURE CAP

The best time to check engine oil level is after the vehicle has sat overnight. or if the engine has been running, allow the engine to be shut off for at least 5 minutes before checking oil level.

Checking the oil while the vehicle is on level ground will improve the accuracy of the oil level reading. Remove dipstick (3) and observe oil level. See Fig 1.

Fig 2: View Of Engine Oil Dipstick
GC0021244Courtesy of CHRYSLER LLC

Add oil only when the level is at or below the MIN mark. See Fig 2.

CAUTION: Do not operate engine if the oil level is above the MAX mark on the dipstick. Excessive oil volume can cause oil aeration which can lead to engine failure due to loss of oil pressure or increase in oil temperature.