LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Fuel System) >> Fuel Injection >> Throttle Body >> Removal >> Throttle Body - 2.4L Turbo

Throttle Body - 2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Throttle Control Shield - 2.4L Turbo
GC0021640Courtesy of CHRYSLER LLC
  1. Disconnect the negative battery cable.
  2. Unlock and disconnect the electrical connector for the inlet air temperature sensor.
  3. Unlock and disconnect the electrical connectors from the idle air control motor and throttle position sensor.
  4. Remove the throttle control shield.
    Fig 2: Throttle Cables
    GC0021675Courtesy of CHRYSLER LLC
  5. Remove the throttle cable from the throttle body cam.
    Fig 3: Throttle Cable Bracket
    GC0021674Courtesy of CHRYSLER LLC
  6. If equipped with speed control, remove speed control cable from the throttle cam by sliding clasp out hole used for throttle cable.
  7. Remove the 2 screws for the throttle cable bracket.
  8. Remove bracket.
    Fig 4: Throttle Body Bolts - 2.4L Turbo
    GC0021671Courtesy of CHRYSLER LLC
  9. Disconnect the throttle body inlet hose and remove from throttle body.
  10. Disconnect the purge hose from the throttle body.
  11. Remove the 3 bolts from the throttle body.
    Fig 5: Throttle Body - 2.4L Turbo
    GC0021672Courtesy of CHRYSLER LLC
  12. Remove the throttle body.
    Fig 6: Throttle Body Gasket- 2.4L Turbo
    GC0021673Courtesy of CHRYSLER LLC
  13. Clean and replace gasket.
scientia non olet · About LEMON Manuals